Replacement Socket Cap

Fits most BMW, Powerlet and Hella sockets. With spring loaded weathertight cap. Stainless steel spring and brass hinge pin. Why wait for yours to break?

PMI-009 $4.70

Rubber Socket Boot Straight

Oil & weather resistant high-durometer rubber provides additional protection for Powerlet sockets and connectors under harsh conditions.

PMI-010 $4.70

Rubber Socket Boot Right Angle

Oil & weather resistant high-durometer rubber provides additional protection for Powerlet sockets and connectors under harsh conditions.

PMI-011 $4.70

Multi-Fit Bracket (6mm mount hole)

Powder coated aluminum mounting bracket for Powerlet Socket. 6mm bolt hole means you can mount a power socket just about anywhere. Under seat, on footpeg plate, etc.

PBR-001-B $18.95

Multi-Fit Bracket (8mm mount hole)

Powder coated aluminum mounting bracket for Powerlet Socket. 8mm bolt hole means you can mount a power socket just about anywhere. Under seat, on footpeg plate, etc.

PBR-002-B $18.95

Bent Bracket Left (8mm mount hole)

Powder coated aluminum mounting bracket for Power Outlet. Made for recessed locations, behind primary cover, etc.

PBR-008-L $23.70

Bent Bracket Right (8mm mount hole)

Powder coated aluminum mounting bracket for Powerlet Socket. Made for recessed locations, behind primary cover, etc.

PBR-008-R $23.70

Dual Socket Bracket (8mm mount hole)

Powder coated aluminum mounting bracket for two Powerlet Sockets. 8mm bolt hole means you can mount two power sockets just about anywhere. Under seat, on footpeg plate, etc.

PBR-003 $21.80

'L' Bracket (8mm mount hole)

"L" Bracket is used when there is a snug area to mount in. It gives you an extra length for clearance.

PBR-004 $18.95

Chrome Bracket (8mm mount hole)

Chromed stamped steel mounting bracket for Powerlet Socket. Has an 8mm mounting bolt hole.

PBR-010 $23.70

Aluminum Socket Washer

Same washer as comes with a Powerlet socket. Use for backing a rubber washer behind a panel when mounting a socket.

PMI-013 $1.10

Thick Rubber Socket Spacer

Reduces clearance necessary behind panel by .31 inch. This thick washer moves the socket out from the top of the panel for maximum clearance on the rear of panel.

PMI-008 $1.38

Regular Rubber Socket Spacer

Same rubber spacer that comes with a PL Socket, gives the socket some flexibility to help take strain off of mounting panel.

PMI-015 $1.38

Steel Rearset Spacer Washer M8

When mounting a bracket to a passenger footplate, this spacer is used on the second hole to keep the plate straight.

PMI-006 $1.10

Cigar Socket Cap

Perfect solution to keep foul weather out of your inline cigar socket. Slips directly over the end and is friction fit so it stays in place.

PMI-003 $1.95

Inline Cable Socket Cap

Keeps foul weather out of your Powerlet cable mounted socket when it's not in use. Slips directly over the end and is friction fit so it stays in place.

PMI-007 $1.10

Powerlet Inline Socket Clip (clip only)

Mountable with a single screw. This clip provides a convenient way to hold a cable mount Powerlet socket. Holds the socket when not in use.

PMI-005 $2.25

Cigar Cable Socket Clip (clip only)

With two screw mount holes this clip provides a convenient way to hold the cigar end of any cable. Holds the socket when not in use.

PMI-004 $2.25