Motorcyle Flasher Units
Table of Contents
Electronic & mechanical flasher/relay units for motorcycles. Operating voltage from 12v though to 16v. If using incandescent bulbs, please make sure the stated power rating of the flasher unit is not exceeded. All units work with LED or incandescent bulbs. Can type is compatible with older Kawasaki’s. CS flasher unit can connect to a switched output from a CS Kit, PC4E or PC-8E and provides a flasher signal for the indicator switch.
CS Flasher Unit
Motorcycle flasher unit in waterproof housing. The unit is potted with heat conducting epoxy so the unit itself if very tough. Connectors are waterproof. Can be ordered with 4mm bullets or MT 090 connectors.
Rated at 70W continuous. Voltages from 12v though to 16v. Suitable for LED & Incandescent bulbs.
For incandescent bulbs we recommend 12W bulbs but bulbs up to 16W can be used.
When ordered with MT 090 connector on the input, the CS Flasher can be connected to the output of any CS kit or PC-4E or PC-8E to provide a flasher output for your cafe racer or custom bike build.
Classic Indicator Flasher Unit
Classic styled motorcycle flasher unit. Aluminum can and sealed against the weather. 2 Pin connctions. X to Power & L to the indicator switch. Works with LED & Incandescent bulbs. Rated at 120W max ( 30W max per indicator ). Non adjustable.
Adjustable Flasher Unit
Adjustable flasher unit for motorcycles. 3 Pin type. 100W max load. 12v. Can be adjusted from about once per second to 5 times per second. Works with LED or incandescent bulbs. 29mm wide/deep.