CRF1000L Electronic Fuse Box
Table of Contents
NOTES:
PowerLink: If Main Fuse Option is selected, then PowerLink Jumper leads cannot be used. PowerLink splitters and high power horn kits can be used.
Bullets: If ordered with Bullets on the Outputs, then mating Bullet connectors will be provided.
MT-090 Connectors: If ordered with MT-090 sealed connectors on the outputs, then mating MT-090 pigtails will be provided plus some 4mm bullet connectors.
MT-090 sealed connectors on outputs shown. Default kit has 4mm Yazaki bullets on outputs.
CRF1000L PC-8E Electronic Fuse Box
Electronics fuse box with 8 circuits, of which 2 are battery direct and 6 are switched. Rated at 45A continuous. Switched outputs are 10A, 10A, 15A, 5A, 5A, and 15A respectively. Waterproof, rugged design. Circuits are reset, by cycling the ignition. No more replacing fuses. LED’s indicate eFuse status. Power good signal on front.
CRF1000L PC-4E Electronic Fuse Box
Electronics fuse box with 4 circuits, of which 1 is battery direct and 3 are switched. Rated at 30A continuous. Switched outputs are 10A, 10A and 15A respectively. Waterproof, rugged design. Circuits are reset, by cycling the ignition. No more replacing fuses. LED indicates eFuse status. Power good signal on front.
Option Accessories
CS Kit Extensions
– pre-made solutions to connect from the CS Kits to your accessory.
– male connector on one end and a female on the other end, male plugs into a CS Kit output connector – then you can use one of the included (comes with every CS Kit) male connectors on your accessory wires to complete the circuit – give you a modular way to connect your circuits
CS Kit Leads with SAE Plug
CS connection to SAE. 2 Prong SAE Plug for battery chargers, etc., WITH 16 AWG wire. (NOW WITH SAE CAP)
CS Kit Leads with T-Connector
CS connection to Powerlet & Hella connection. 2 Prong T-Connector for Powerlet and Hella type Socket – with 18 AWG wire
CS Kit Leads with .250″ Spade Connector
CS connection to Powerlet & Hella connection. 2 Prong T-Connector for Powerlet and Hella type Socket – with 18 AWG wire
CS Kit Sealed Splitter
These splitters are designed to allow you to power even more accessories from your CS Kit.
All splitters are 15 cm(6”) long.
They are made of high quality Yazaki wire of 0.75 sqmm (18 AWG), with high temp flexible sheathing.
You can order any of the combinations below and more. Pick the connectors you need for your accessories.
2 Pin MT 090 Sealed Connector.
2 Pin MT 090 waterproof connectors. As used on CS kits. Includes terminals and seals.
Kit Checklist
Packing List
- PC-4E Electronic Fuse Box
- Switching Lead
- PowerLink to Battery Lead
- 2 x 150cm Pigtails
- 2 x 50cm Pigtails
- 4 x MT 090 Male Connectors with Seals & Terminals
- Velcro – 2 Strips
- Installation Notes: