Yamaha MT-07 Gen 4 Electrical Accessories
Table of Contents
MT-07 PC-4E Accessory Fuse Box – [2025- ]
This is an accessory fuse box for the Yamaha MT-07 Gen 4 2025- . It is a compact and powerful electronic fuse box. Installation is plug and play so no modifying your bike OEM wiring. Provides 3 switched and 1 battery direct connection. Outputs can be split into two, provided rated current is not exceeded. Switched outputs activate when the bike is powered up. The electronic fuse box never needs replacement fuses. If a fuse is tripped, simply cycle the ignition and it will reset any tripped fuses. If the fault still remains, the fuse will simply switch off. You can connect heated gear though the battery direct output. Kits can be optioned up with a PowerLink Jump leads to allow jump starting.
MT-07 H4 Headlight Kit – [2025- ]
H4 headlight for the 2025- MT-07 ( LED headlight ). It allows you to replace the stock headlight with an aftermarket H4 or other headlight ( you can email us and request other than a H4 connection ). Plug and play. OEM Hi/Lo switch will operate the H4 headlight.
Low Beam OR High beam – only one on at any given time.
Low Beam OR Low Beam + High Beam – both on when High Beam is on.
MT-07 Headlight Break Out – [2025- ]
Headlight break out adapted. Provides access to high beam and low beam signals. Built in inverter to covert the 0v High Beam signal to 12v. Also has built in noise suppression for driving relays. Plus is controlled by the High Beam switch. Allows you to control a H4 or other headlight. Current limit is 0.5A so should only be used to drive a relay or low current input.
Yellow = High Beam Out ( 12v when High Beam is On. Switched Off when Low Beam is On )
Blue = Low Beam Out ( 12v when Low Beam is on. Switched Off when High Beam is On )
Red: Low Beam always on Out ( 12v when engine is running and always on even if High Beam is On )
MT-07 Tail Light Splitter – [2025- ]
H4 headlight for the 2025- MT-07 ( LED headlight ). It allows you to replace the stock headlight with an aftermarket H4 or other headlight ( you can email us and request other than a H4 connection ). Plug and play. OEM Hi/Lo switch will operate the H4 headlight.
Low Beam OR High beam – only one on at any given time.
Low Beam OR Low Beam + High Beam – both on when High Beam is on.
MT-07 Indicator Break Out Cable – [2025- ]
Indicator break out cable. You can use to connect extra indicators ( such as in a top box ) or to wire in aftermarket indicators without damaging the OEM harness. Made from high quality 100% copper wire, with high temp tubing and original Japanese connectors. Rear indicator connectors are under the pillion seat clipped into the undertail plastics. Front indicator connectors are under the tank side panels. Ground and signal wires provided. Plug and play.
MT-07 Plate Light Splitter – [2025- ]
Plate light splitter for the 2025 and later MT-07. Provides a source of switched power, under the seat. Can be used for top box connections or extra tail lights or fuse box trigger inputs. Recommend to keep current draw to 1A or under. This connection is not for high power. Cables is hand made using the best quality Japanese wire, sleeving and connectors.
The plate light connector is under the pillion seat, to the left just under the left side indicator connector and a little forward of the indicator connector ( not immediately visible you have to move the indicator connector to see it. )
Other Fuse Panel Options: CS Kits, for more modest power needs.