Super Tenere 1200 CS Kits
Table of Contents
The CS HD kit has higher current capability using non sealed connectors.
The standard CS kit ( 4CS ) uses all sealed connectors.
The CS kits are accessory fuse box kits for connecting electrical accessories such as USB ports, navigation systems, heated grips etc. They allow you to clean up your battery posts ( remove all those wires ) and have each circuit fused. and protected. They are flexible and easy to install. Plug and play so no modifying your bike.
Yamaha Super Tenere 3CS HD Kits
The 3 Circuit Solution gives you 3 fused outputs with one circuit always hot and two switched. Easy to install. This custom kit uses the Auxiliary Lights connector near the battery for an easy plug in install for relay switching. Comes with fuses and cable ties, plus mating connectors.
This Kit can be used for higher current needs. Each circuit of the HD unit is 15A capable. Total maximum current draw max for the HD Kits is 35A. This Kit uses unsealed .250″ connectors that are easy to work with if crimping or soldering.
There is also a PowerLink option that allows optional PowerLink accessories such as our Jump Start cable to be easily connected. The standard kit mounts under the front right fairing ( near the battery ). The Long version mounts under the riders seat.
3CS HD Splitter
These leads are an extension for the 3CS-HD outputs. Available in 3 lengths and made from the highest quality components. Made with high temp 16 AWG wire and high temp sheathing.
3CS HD Extension Leads
These leads are an extension for the 3CS-HD outputs. Available in 3 lengths and made from the highest quality components. Made with high temp 16 AWG wire and high temp sheathing.
3CS-HD Leads with SAE Plug
These leads are an extension for the 3CS-HD outputs. Available in 3 lengths and made from the highest quality components. Made with high temp 16 AWG wire and high temp sheathing.
2 Pin Yazaki .250″ CN(A) Tang-less
Extra connectors for the 3CS-HD. Terminals included.
4CS Fuse Box Kits
Yamaha Super Tenere 4CS Kits
4 output fuse box. Rated at 30A total. Max 15A per output. Flexible design make for easy installation. Plug and play kit. Fuse holders hold a spare fuse. For modest power users. Cost effective solution to clearing up the mess at the battery posts.
CS Kit Extensions
– pre-made solutions to connect from the CS Kits to your accessory.
– male connector on one end and a female on the other end, male plugs into a CS Kit output connector – then you can use one of the included (comes with every CS Kit) male connectors on your accessory wires to complete the circuit – give you a modular way to connect your circuits
CS Kit Leads with SAE Plug
2 Prong SAE Plug for battery chargers, etc., WITH 16 AWG wire. (NOW WITH SAE CAP)
CS Kit Leads with T-Connector
2 Prong T-Connector for Powerlet and Hella type Socket – with 18 AWG wire
CS Kit Leads with .250″ Spade Connector
2 Prong T-Connector for Powerlet and Hella type Socket – with 18 AWG wire
CS Kit Sealed Splitter
2 Prong T-Connector for Powerlet and Hella type Socket – with 18 AWG wire
2 Pin MT 090 Sealed Connector.
CS Kit spare connectors. Sold with terminals and seals.