Due to Summer Holidays in Japan, shipping during the week of the 3rd though the 7th will be delayed ( post office and Fedex have a holiday ). However orders will be shipped in the sequence received and we hope to have shipping back to normal from the 10th. We apologize for any inconvenience.
Rectifier DC Side Fused Cable - QLW 3 Pin
Rectifier DC Side Fused Cable - QLW 3 Pin - Image 2

Rectifier DC Side Fused Cable – QLW 3 Pin

$29.95

SKU: aa-reg-part-a-dc-qlw Categories: , Tags: , , , , , , ,

Description

Part A – R/R Unit to Battery – 36” (92cm) 12 gauge 100 C wire, sealed fuse holder, and high temp sheathing. Battery ring terminals and Sumitube shrink-tube are included, as well as cable ties and two 30A fuses. Hook-up is direct to battery, bypassing the stock 30A fuse holder on the bike which can be a problem with age.

Part A is now only available with the Metri-Pack 630 ATO/ATF full size blade fuse holder shown to the right. The MP280 is a good fuse holder, but for this application I feel the larger size fuse gives better conduction and less heat.

– battery terminals are left off so you can trim wires to fit – solder them on for best results

– if you use crimp-on battery terminals, you MUST use a good crimper for a good connection, this is VERY IMPORTANT! For best results, crimp/pinch and solder on the ring terminals that are included with this Kit. And make sure you use the Sumi-tube on the terminals for wire strain relief and moisture resistance. Put the Sumi-tube pieces over the wires before attaching the ring terminals!

Related products