Description

These adaptors are handy when you’re adding bar risers and need more length in the stock wiring.

NOTE: Some very early VStroms have a different right side connection, see below. I urge you to check your connections before ordering.
2012 on DL650s are using the 4 pin lead instead of the Horn Extension. These bikes also use the Left and Right Bar Extensions.
The new DL1000A is unknown if it’s changed, or like the 2012 on DL650s. Check yours if unsure.

All the adaptors above give a 10 inch (25 cm) extension to the handlebar wires.

PLEASE NOTE CAREFULLY: The VStrom headlight wiring normally runs through these connectors. The VStrom has no headlight relays from the factory so the current is quite high. Eventually heat develops at the point of most resistance. Arcing happens and eventually connection is lost and the connectors look black and burnt. You likely lose your headlights. Adding these adapters without adding headlight relays adds to the overall resistance of the headlight wiring, therefore increasing the chance of a meltdown on a connector. I always recommend adding one of my H4 Dual Headlight Relay Kits to any VStrom, but when adding these bar wire extensions it is a MUST.