Description

MT-07 Headlight Break Out – [2025- ] ( fourth generation ).

Plugs into the OEM harness with a pass though connection and allows access to the High beam, low beam signals. Also, has a built in inverter so the high beam signal ( which is normally 0v when active ) is converted to 12v when active. There is also noise suppression built in for connected relay switching, to protect the bikes electronics. Lastly there is noise suppression in the switching, to ensure clean switching. The OEM high beam switch will control the output.

Output Limit:
This unit is designed to switch on relays, not power lights or high current devices.  Maximum, current draw is 0.25Amps on any connection. Use to drive external relay. DO NOT USE TO DRIVE ANY SOURCE THAT NEEDS MORE THAN 0.25A.

Connection:
Using Yellow & Blue wire: High beam On Yellow = 12v, Low Beam On blue = 12v. Which ever is off will be 0v ( so low beam switched off when high beam is on )
Using Yellow and Red wire: High beam On Yellow = 12v & Red = 12v, Low Beam On Red = 12v. Yellow = 0v ( so low beam is always on )
Yellow:  High beam out ( active high or 12v when high beam is on )
Blue:  Low beam output ( active high or 12v when low beam in on )
Red: Ignition On & Engine running signal ( always on when engine is running ).

The unit plugs between the headlight and the OEM headlight connector. It sits behind the headlight inside the shell. Its designed to fit in there nicely. The board is potted with temperature wicking epoxy both effecting improved cooling and weather tolerance.